17B-11
PETROL INJECTION
Position and speed sensor
K7J, and 710
17B
Program with the engine flywheel target after repla-
cing the speed and position sensor (1) or the engine
flywheel:
-make a deceleration with injection cut-off in se-
cond, third, fourth or fifth gear between 3,500 and
3,000 rpm, for at least 2 seconds,
-make a second deceleration with injection cut-off in
second, third, fourth or fifth gear between 2,400
and 2,000 rpm for at least 3 seconds.
Using the diagnostic tool, check that this program-
ming is properly done, ET060: « Flywheel signal
with engine running ».
Read the fault codes.
Repair if necessary.
Clear the fault codes.
Check that the vehicle is working correctly.
Essential equipment
diagnostic tool
109211
1
To Next Page
Loading...