11A-18
TOP AND FRONT OF ENGINE
Accessories belt
L90, and K7M, and 710, and DIRECTION MANUELLE, and BASIC HEATING
11A
Refit the accessories belt.
Tension the belt by turning the alternator.
Set the belt tension using tool (Mot. 1505) or (Mot.
1715) to a value of 305 Hz ±±
±±
10, (see Technical
Note 3786A, Engine and peripherals, 10A, Belt
tension tester: Use).
Turn the engine through three revolutions to position
the belt correctly.
Check the belt tension using tool (Mot. 1505) or (Mot.
1715).
If the belt tension is outside tolerance, readjust it.
Torque tighten:
-the alternator mounting bolt (2.1 daNm),
-the alternator mounting bolt (4.4 daNm).
Proceed in the reverse order to removal.
Torque tighten the wheel bolts (10.5 daNm).
16300
(3)Crankshaft
(4) Alternator
(5) Measuring point
WARNING
Connect the battery, starting with the positive ter-
minal; carry out the necessary programming (see
80A, Battery: Remove and Refit).
5
4
3
To Next Page
Loading...