To Next PageTo Next PageWhy does the saw head rattle when lowered on my Logosol B751 Saw?
If the saw head of your Logosol Saw rattles when lowered, it could be because the rail component is not flat and breaks in the saw carriage. Weigh down the rail component as instructed to ensure it is flat.
Explains warning symbols and general safety precautions.
Details safety features of the band sawmill itself.
Rules for the operator's personal safety and conduct.
Guidelines for preparing and maintaining a safe work environment.
General guide to rail assembly and associated safety warnings.
Instructions and precautions for adjusting the rail's alignment.
Attaching tensioning profiles to the log bed.
Installing the adjustment arm and log support components.
Steps for lifting and placing the saw head onto the rail.
Attaching anti-tip plates and the rail scraper for safety.
Instructions for assembling the crank mechanism.
Fitting the handle and tensioning the chain linkage.
Ensuring the rail is perfectly level for accurate sawing.
Adjusting the wheels for proper alignment with log beds.
Positioning the saw blade correctly in the longitudinal direction.
Ensuring the saw blade is parallel to the log beds for precise cuts.
Setting the adjustable blade guide horizontally for straight kerfs.
Ensuring the saw blade is parallel to the rail for proper functioning.
Adjusting the throttle cable for precise engine speed control.
Checking rail scrapers and setting correct blade tension.
Adjusting chain linkage and setting the measurement gauge.
Adjusting log support perpendicularity and drive belt tension.
Setting the crank mechanism and adjusting blade guides.
Explains the crank mechanism for saw head height adjustment.
Describes millimetre/inch gauges and the Last Cut indicator.
Details the parking lock and eccentric log clamp functions.
Covers cutting tool safety, risk of entrapment, and modification warnings.
Lists checks before starting and before each sawing cut.
Warns about burn injuries, fire hazards, and safe operating distances.
Guidelines for preparing logs and safely loading them onto the sawmill.
Steps for setting cut depth, sawing, and rotating logs.
Procedures for handling and stacking sawn timber.
Outlines required maintenance intervals and lubrication points.
Safe practices for handling and replacing bandsaw blades.
Procedures for cleaning the sawmill and checking key components.
General
