Lorex ECO LH100 SERIES - Front Panel Controls and Indicators

2
FRONT PANEL
1. Power: Press to power the system ON/OFF.
2. IR Sensor:
IR receiver for the remote control.
3. LED Indicators: Shows s
tatus of HDD, recording, alarm, network, and power.
4. Channel/Numbers/Playback:
Press buttons 1~4 (4-channel models) or 1~8 (8-channel
models) to view the selected channel in full-screen; press buttons 1~0 to input passwords
and user IDs; during playback, press the following:
• 6/
: Increase reverse playback speed 1X, 2X, 4X
• 7/
 : Press to freeze playback to one frame, then press again to advance frame-by-frame
• 8/
: Press to start playback
• 9/
: Press to slow playback speed by 1/2, 1/4, 1/8
• 0/
: Press to increase forward playback speed 1X, 2X, 4X
5. MENU/EXIT: Pr
ess to open/close the main menu.
6. Navigation/OK: Pres
s the Navigation buttons to perform the following:
• OK/PTZ:
In menus, press to confirm selections; in PTZ mode, press to change the navigation
buttons to control the connected PTZ camera (not included)
•
S: Press to move cursor up; in PTZ mode, press to pan camera up
•
T: Press to move cursor down; in PTZ mode, press to pan camera down
•
W: Press to move cursor left; in PTZ mode, press to pan camera left
•
X: Press to move cursor right; in PTZ mode, press to pan camera right
7. USB: Connect
a USB flash drive to the top port for data backup and firmware upgrades;
connect a USB mouse to the bottom port.
1
6
2
3 4 5 7
11