35
Using Remote Surveillance
PTZ
The PTZ tab allows you to configure the
settings for connected PTZ cameras (not
included).
NOTE: Please refer to the instruction manual of
your PTZ camera for complete details on
configuring your camera settings.
To open PTZ setup:
• Click SETUP at the top of the
main screen
and then click PTZ
Configure PTZ settings for each channel with a
connected
PTZ camera (not
included):
NOTE: Click NEXT/PREVIOUS for additional
channels (8-channel models only).
• PROTOCOL: Select PELCO-D or PELCO-P
• ADDRESS: Select from 1~255
• BAUD RATE: Select 1200, 2400, 4800, or
9600
• DATA BIT: Select 5, 6, 7, or 8
• STOP BIT: Select 1 or 2
• VERIFY: Select ODD, EVEN, MARK,
SPACE, or NONE
Click APPLY to
save your settings and then
click OK in the confirmation window.
NETWORK
The Network tab allows you to configure your
IP and DDNS settings.
To open Network setup:
• Click SETUP
at the t
op of the main screen
and then click NETWORK
To configure IP settings:
1. Under TYPE, select DHCP (def
ault),
PPPoE, or STATIC. If
DHCP, go to
step 5
. If
PPPoE, go to
step 2
. If STATIC, go to
step 3
.
NOTE: DHCP allows you to quickly connect to
your network by obtaining an IP address from
the router. After the initial setup, we recommend
that you disable DHCP and set the IP address
between 1~100. For example, if your IP address
is 192.168.0.107, change the last digits to 90 (i.e.
192.163.0.90). This ensures that port forwarding
will not change in the event of power failure or
resetting of your network.
2. If you select
PPPoE
in step 1, enter your
PPPoE user name and password in the
respective fields.
To Next Page
Loading...
