53
APPENDIX D: CONNECTING A PTZ CAMERA
You can connect RS-485 PTZ cameras (not included) to the PTZ Control Block on the rear panel of
the system. Additional PTZ cameras are available at www.lorexcctv.com
To install a PTZ Camera:
1. Connect the Transmit Cable to the 485A TX
(+) port of the PTZ block on the rear panel.
2. Connect the Receive Cable to the 485B RX
(-) port of the PTZ block on the rear panel.
3. Connect the video cable to a BNC port.
4. Open the MAIN MENU and then click ADVANCE. The Adv
anced Setup menu opens.
5. Click PTZ.
6. Configure the settings based on the instructions of your PTZ camera and click APPLY.
NOTE: The PTZ camera settings depend on the type of PTZ camera. Please refer to the specific camera
manual for your brand and model of PTZ camera.
To use a PTZ camera:
1. Make sure the camera is properly connected and configured
prior to usi
ng the PTZ camera.
2. From live viewing, right-click anywhere on
the screen to open
the sub-menu and select PTZ. The PTZ control panel opens.
3. Click the navigation keys to move the lens.
4. Click and drag the slider to adjust panning speed.
5. Click + / - to co
ntrol Zoom, Focus and Iris.
6. Click SETUP to
open Senior Control.
To use Senior Control:
1. Under Preset, enter a number using the Virtual Keyboard
(mouse onl
y).
Click Set Preset to save the preset.
2. Click Clean Preset t
o erase a preset.
3. Click Call Preset t
o set a preset.
4. Click Auto
Scan to scan for presets. Click Stop Scan to stop the
scan.
5. Click EXIT t
o close the Senior Control menu.
DVR
PTZ CAMERA
(not included)
Figure 37.0 Connecting a PTZ camera (not included)
Figure 37.1 PTZ control
Figure 37.2 PTZ Senior control
To Next Page
Loading...
