33
Using Remote Surveillance
Remote Setup
Use the Setup tab to configure the settings of
your system from a remote location.
NOTE: If the Main Menu is open on the system,
you will not be able to make changes to the
system from the remote location.
To open remote setup:
• Click SETUP at the top of the main
screen.
The Remote Setup menu features the
following tabbed options:
RECORD
The Record tab allows you set recording
parameters on the system as well as program
a recording schedule.
• CHANNEL: Click the dr
op-do
wn menus for
the respective channels and select ON/
OFF to enable/disable recording. If OFF,
the channel will not record
NOTE:
Click NEXT and PREVIOUS to view
additional channels (8-channel models
only)
• RESOLUTION: Check (non-selectable)
• QUALITY: Select BEST, FINE, or NORMAL
• AUDIO: Select ON/OFF
NOTE:
Audio capable cameras (not
included) are required for audio recording.
• REC. MODE: Select POWER UP or TIMER
RECORD; if your select POWER UP, the
system will automatically begin recording
continuously whenever the system is
restarted; if you select TIMER RECORD,
you can click SCHEDULE to program a
recording schedule
• SCHEDULE (TIMER RECORD must be
selected):
Click DEFAULT to
restore factory settings.
Click APPLY to s
ave your changes and then
click OK in the confirmation window.
SCHEDULE
To enter a recording schedule remotely:
1. Click SETUP at the top of the main scr
een.
The Record menu opens by default.
2. Under REC. MODE
, select TIMER RECORD
and then click SCHEDULE. The Schedule
window opens.
3. From the drop-down menu at the top of the
window
, select the desired channel or
select ALL.
4. At the bottom of the window, select either
ALARM, NORMAL, or NO (n
o recording).
5. Click the time blocks from 0~23 for the
desir
ed
day of the week.
• : (blue) selected block
• :
(red) alarm
• : (green) normal
• : (clear) no recording
6. From the COPY/SET TO dr
op-down menus
to copy the schedule of one day to another.
For example, if you want your schedule for
Monday to be the same on Wednesday:
under COPY select MON, under SET TO
select WED, and then click COPY.
7. Click APPLY and
then click OK in the
confirmation window.
8. Click EXIT to
close the Schedule window.
• RECORD
• ALARM
• PTZ
• NETWORK
• SETTING
• HOST INFO
To Next Page
Loading...
