Lorex ECO LH100 SERIES - Remote Control

5
REMOTE CONTROL
The remote control is the secondary input device
for navigating the system’s interface.
To use the remote control:
1. STANDBY: Press to turn standby mode ON/OFF.
2.
LOGIN/LOCK: If "Security" has been enabled in the
Setup menu, press to open the user password login
screen.
3.
Number/Channel buttons: While in menus,
press buttons 0~9 to enter values; during live
viewing, press to view channels in full-screen.
4. : Press to switch between quad and
split-screen displays.
5. MENU: Open
s the main menu.
6.
PTZ: Press to open the PTZ control window.
7.
EXIT: Close menu windows.
8.
Navigation/OK:
• S/CH+: Move cursor in menus up; Channel Up.
• X/FWD: Move cursor in menus right; during
playback, increase forward playback speed (5X, 15X,
60X).
• W/
REW: Move cursor in menus left; during
playback, increase reverse playback speed (5X, 15X,
60X)
• T/
CH-: Move cursor in menus down; Channel down.
• OK: In menus, press to confirm selections; during
playback and preview, press to view system
information
9. +/ - : In menus, press to adjust values.
10. RECORD: Pres
s to start manual recording.
11. STOP: Pr
ess to stop manual recording.
12. EXTRA: Open
the system menu.
13.
Playback controls:
• : Increase reverse playback speed 1X, 2X, 4X
• : Press to start playback
• 
: Press to increase forward playback speed 1X, 2X, 4X
• 
: Press to slow playback speed by 1/2, 1/4, 1/8
•  :
Press to freeze playback to one frame, then p
ress again to advance frame-by-frame
14. AUDIO: Press to open the Audio recording menu.*
15. MUTE: Pre
ss to mute listen-in audio on the system.*
Figure 2.0 Remote Control
6
1
2
3
4
5
6
7
8
9
9
10
12
11
12
*Audio capable cameras (not included) are required for audio
recording and listen-in audio functionality.
TIP: When using the remote control to
enter password and camera titles,
select the field using the navigation
buttons, press ENTER, and then press
the number buttons.