70
Troubleshooting
Troubleshooting (cont’d.)
Error Possible Causes Solutions
• Mouse not detected
by system
• Mouse cable is not firmly
connected to the system
• Firmly connect the mouse cable to the USB Mouse
port on the front panel
• Mouse is not connected to the
system
• System needs to be reset • Power off the system (disconnect power cable).
Firmly connect a USB mouse to the USB Mouse port
on the front panel of the system. Reconnect the
power cable to the DC 19V port on the rear panel.
• There is no picture
on selected channels
/ camera picture is
not being displayed
• Camera cables are loose or
have become disconnected
• Check the camera video cable and connections
• Disconnect and reconnect the cable at the system
and at the camera
• Try moving the camera to another channel or use
another cable
• The image on the
DVR appears, but
does not have sound
• Audio cables are loose or have
been disconnected
• Check the AUDIO connections to the DVR
• Audio channels are disabled in
the system menu
• Check the Configurations: Main
Menu
>Record>Audio
• Volume on external speakers
(not included) is low or off
• Increase volume on external speakers (not
included)
• A "whirring" noise
is coming from the
system
• Fan is active • The noise means the exhaust fan is working
normally.
• The system beeps
at startup
• The beep at startup is normal
• The system beeps
during motion
detection
• Motion detection is enabled, but
the alarm buzzer is activated
• Open the Main Menu and click ADVANCE
• Click ALARM; set the Buzzer to 0s and click
APPLY
• I am not receiving
email notifications
• Email notification is disabled • Open Main Menu
>Advance>Alarm; click EMAIL
SETUP; under EMAIL select ON
• Default setting is disabled, but
you have not entered your own
SMTP information
• If you want to use your own SMTP server, deselect
the Default box, and enter your SMTP Server
address, Port, User name, and Password in the
respective fields
To Next Page
Loading...
