22
Using the Main Menu
• HDD LOSS: the alarm will sound if the
internal HDD is damaged
• HDD SPACE: the alarm will sound when
the HDD is full (overwrite must be
disabled)
• VIDEO LOSS: the alarm will sound when
a camera is disconnected
3. Under ALARM MANAGE, configure the
following:
• OUTPUT: Set the output time (in seconds)
on
the spot monitor from 0s, 10s, 20s, 40s,
or 60s
• BUZZER: Set the time (in seconds) for the
buzzer when an alarm is triggered—0s,
10s, 20s, 40s, or 60s
NOTE: Set the buzzer to 0s if you want to disable
the alarm during motion detection
• POST REC: Set the time (in seconds) for
the system to record after a triggered
alarm—0s, 10s, 20s, 40s, or 60s
4. Click APPLY. Click CLOSE in the
c
onfirmation window.
ALARM SETUP
Click ALARM SETUP and select ON/OFF to
apply an external alarm trigger to a channel.
EMAIL SETUP
The system can send an email notification with
a JPEG snapshot for triggered events on the
system.
To setup email notification:
1. Under EMAIL, select ON.
2. Under SSL, select OFF.
NOTE: SSL deals with encryption. Only advanced
users should enable this option.
3. Under SMTP PORT, enter the SMTP port of
your email server.
4. Under SMTP, enter the SMTP addr
ess of
your email server. For example,
smtp.connection.ca
5. Under SEND EMAIL, enter the sender
email addres
s.
6. Under SEND PW, enter the password of
you
r email server.
7. Under RECV EMAIL, enter the email
addres
s that will receive the email
notification.
8. Click APPLY. Click CLOS
E in the
confirmation window.
9. Click EXIT in all
menus until all windows
are closed.
INFO
View system information, including the IP
address, MAC address, and HDD capacity of
the system.
To view system information:
1. From the Advanced Setup menu, click
INFO.
or
1. From Live viewing, press the OK button on
th
e front panel of the system.
2. View the system’s IP address, MAC
addres
s, Disk Capacity, Video Signal Type,
Net Client Port, and Web Server Port. Click
OK to close the menu.
Figure 15.1 Email Setup menu
Figure 16.0 System Information