34
Using Remote Surveillance
ALARM
The Alarm tab allows you to configure alarm
settings as well as set motion detection.
To open Alarm setup:
• Click SETUP at the top of the
main screen
and then click ALARM.
Configure the following alarm and motion
dete
ction settings for each respective channel:
NOTE:
Click NEXT/PREVIOUS for
additional channels (8-channel models
only)
• I/O ALARM: Select NO (normal open), NC
(normal close) or OFF
• MOTION DETECT: Configure the following:
• STATUS: Select ON/OFF to enable/disable
motion detection
• SENSITIVITY: Sel
ect HIGHEST, HIGH,
NORMAL, or LOW
• MD (motion d
etection) AREA: Click SETUP to
open the Motion Grid (see Motion Grid on page 36)
• VIDEO LOSS: Select ON/OFF to enable/
disable the alarm when a camera is
disconnected
• HDD SPACE: Select ON/OFF to enable/
disable the alarm when the hard drive is
full (Overwrite must be turned off)
• HDD LOSS: Select ON/OFF to enable/
disable the alarm is the internal hard drive
is damaged or incurs failure
• ALARM MANAGE: Configure the
following:
• OUTPUT: Set the time (in seconds) for the
buzzer to sound when an alarm is triggered—0s,
10s, 20s, 40s, or 60s
• PO
ST REC: Set
the time for the system to record
after an alarm is triggered—30s, 1min, 2min, or
5min
Click APPLY to save your settings and then
click OK in the confirmation window.
MOTION GRID
To set the motion grid:
1. Click SETUP at the
top of the main screen
and then click ALARM.
2. Under MOTI
ON AREA, click SETUP for
each respective channel you wish to apply
motion detection. The Motion Grid opens.
NOTE: Click NEXT/PREVIOUS for additional
channels (8-channel models only).
3. Click the blocks to enable/disable motion
detection. RED=motion detection
enabled
;
BLACK=motion detection
disabled
. You can
click and drag to select multiple blocks;
click CLEAR to disable all the blocks.
4. Click CONFIRM an
d then click OK in the
confirmation window.
To Next Page
Loading...
