Using the PC/Mac Client Software
17
2. In the Receiver Email field, enter the email address you want the DVR to send alarm
notifications to.
3. In the Interval drop-down menu, enter the duration the DVR must wait before sending
out a new notification. For example, if you select a 3 minute interval, the DVR will send
out email notifications every 3 minutes until the DVR stops detecting motion / alarm.
The DVR will only send out notifications when it detects motion / alarm triggers.
4. Click Save to save your settings.
If you select "Enable", and want to use your own email server:
1. Configure the following:
• SSL: Select ON/OFF to enable/disable Secure Socket Layer protocol.
• SMTP Port: Enter your SMTP address.
• SMTP Server: Enter your SMTP Server.
• Sender Email: Enter the sender email address. This can be any address of your
choice.
• Sender Password: Enter your email server’s password.
• Receiver Email: Enter the recipient’s email address.
• Interval: Enter the interval the DVR waits before sending a new email notification.
2. Click Save to save your settings.
17.18 Configuring DDNS Settings
The primary connectivity option uses Lorex Stratus Connectivity to connect to your system
over the Internet without requiring port forwarding or DDNS registration (see 16 Connect-
ing to Your DVR Over the Internet on PC or Mac for details). Lorex DDNS is also available
as an optional connectivity option (see 25 DDNS Setup (Advanced), page 147 for details).
To configure DDNS settings:
1. Visit http://www.lorexddns.net and register for a free DDNS account.
2. Click the Remote Setting tab, and click DDNS.
#LX400015; r. 1.0/13705/13705; en-US
87
To Next Page
Loading...
Need help?
General