3 -8
19
Low fuel level warning indicator
When the fuel level in the fuel tank becomes
below minimum level, this indicator will be turned
on. If this indicator turns on, fill the fuel tank
immediately with fuel. When working on the
uphill/downhill, the fuel can be exhausted before
this indicator is turned on. Add fuel in advance.
20
Cold start aid indicator
When the cold start aid device is working, this
indicator will be turned on, and it will be turned
off about some seconds later. It may vary
depending on the ambient temperature. After
this indicator is turned off, start the engine.
21
Engine oil pressure indicator
This indicator will be turned on when turning the key switch to “ON” position and it will be turned off
after starting engine.
The light indicates oil pressure only and goes out when sufficient oil pressure is present at the oil
sender.
If this indicator is turned on during operation, stop the engine and check the engine oil level. If the
engine oil level is normal, contact your authorized local dealer for check.
19 20
21
22
22
Fuel filter warning indicator
When there is a restriction or excess water in the fuel filter, this indicator will be turned on. If this
indicator turns on, remove water in the fuel filter. (See chapter 5-5-(1) in this manual.)
23
DPF Regeneration indicator
When the regeneration process in the DPF is
working, this indicator will be turned on with
continuous light. It is not a failure but normal
operation.
If this indicator is blinking, it means that the
soot is over accumulated in the DPF. Comply
with the instructions of the chapter 3-1-(10),
“DPF switch” in this manual.
For further information about this indicator, see
page 3-20 in this manual.
24
23
25
To Next Page
Loading...
