LSIS XGL-EFMTB - Module Check with XG5000

Chapter 5 XG5000 Program
5-10
Notes
(Note 1) Notice in setting DHCP
(1) To check the IP address after DHCP setting, check IP address in Online -> System diagnosis ->
Detailed module information or click standard setting after executing Open From PLC.
(2) In case of dynamic IP address, IP address is reset when module is disconnected from server or Power
is off
(3) In case of using Remote connection to module using DHCP, when remote side restart, you have to
check the IP address of remote station
(4) In case of using DHCP with XGL-EFMTB/EFMFB, you have to use only port 1.
(1) In case CPU is XGR series
[Fig. 5.2.13] shows specified standard parameters in case CPU is XGR CPU. In case of XGR,
some of items in Standard setting is different according to whether you use ONE IP Solution or
not.