Chapter 5 XG5000 Program
5-14
(2) Setting communication module
[fig.5.3.3] Setting of communication module and communication period
Classification
Description
Communication
module settings
Module type
Select FEnet.
Base No.
Select Base No. the module is installed on.
Slot No. Select Slot No. the module is installed on.
Communication
period settings
Period type
Set the data transmission period.
(available range is 20ms~10sec)
Output data setup
in case of
emergency
Latch
Maintain and send the latest data received from CPU.
It is seen that it is cleared if CPU sends data as 0
even though latch is set. Make sure to check the
emergency output data setting of CPU.
Clear
It sends by setting received High-speed Link data as 0
in ignoring data from CPU. If emergency data is set as
‘clear’ in emergency output data setting of XG5000
High-
speed Link module setting even though
emergency output data setting of device area of High-
speed Link sending part is set as latch in CPU, the
data set as 0 is sent. Make sure to set it after
checking desired operation.
To Next Page
Loading...