hic
Set instrument to default for Polargraphic
Probe operation.
Ø
ØØ
Ø ×
××
×
To use these functions select the “Save/Restore” menu item and use the ”UP” and
“DOWN” keys to select the required function. Pressing the “ENTER” key will
prompt the unit to ask for confirmation. Pressing the “ENTER” key again will
initiate the function. The unit will then perform the function and then return to the
main menu.
This facility is very useful when testing or fault finding is required. The setup can
be stored prior to testing and restored once testing is complete. The two default
setups are provided to give a basic instrument setup for each of the Polargraphic
and Galvanic probe configurations.
Note. There is no protection for the setup stores other than the systems request
for confirmation, so be very careful not to overwrite already saved setups.
To Next Page
Loading...