LTH MOD53 - Appendix C - Factory Default Setups

Appendix C – Factory Default Setups
87
Appendix C – Factory Default Setups
Parameters Galvanic Polargraphic
Units % Saturation % Saturation
Probe Type Galvanic Polargraphic
Temperature Units
°C °C
Temperature Compensation Automatic Automatic
Fixed Temperature Input
+25.0°C +25.0°C
Fixed Salinity Input 0.00 ppt 0.00 ppt
Pressure Compensation Manual Manual
Pressure Units Atm Atm
Fixed Pressure Input 1.00 Atm 1.00 Atm
Set Points
SP1 Source Sensor Sensor
SP1 Trigger Low Low
SP1 Level (Latch High) 50.0% 50.0%
SP1 Latch Low 20.0% 20.0%
SP1 Mode On/Off On/Off
SP1 Dose Alarm No No
SP1 Alarm Time (mm:ss) 05:00 05:00
SP1 Delay (mm:ss) 00:00 00:00
SP1 Hysteresis
(% of SP Level)
1.0% 1.0%
SP1 Cycle Time (mm:ss) 00:30 00:30
SP1 Proportional Latch
(% of range)
20.0% 20.0%