PARTNER Voice Messaging Installation and Programming
Using PARTNER Voice Messaging System Programming
18
Using PARTNER Voice Messaging
System Programming
The System Manager’s mailbox (Mailbox 0) is a special mailbox that is used to program PARTNER
Voice Messaging. The System Manager uses this mailbox to:
■ Assign mailboxes to the PARTNER communications system extensions.
■ Change the system configuration (that is, number of mailboxes).
■ Record a menu prompt (up to two minutes long).
■ Assign Selector Codes (that is, the first digit the caller dials in response to the menu prompt).
■ Initialize a mailbox (to prepare it for use by a new subscriber).
■ Change the System Manager’s password for the System Manager’s mailbox (0).
■ Reinitialize passwords for mailboxes if a subscriber forgets the password.
The factory-set password for the System Manager’s mailbox is 1234. See “Changing the System
Manager’s Password” for instructions on how to change the password.
Although the System Manager’s mailbox has a password, it does not have storage capacity for
messages.
Note that Step 1 of each programming procedure in this chapter is logging into PARTNER Voice
Messaging, which is explained below. If you are already logged into PARTNER Voice Messaging,
you can skip Step 1.
Logging Into System Administration from an
Internal Telephone
To log into System Administration:
1. Call PARTNER Voice Messaging by pressing
i777 or a programmed Voice Mail Auto
Dial button.
2. Enter 0 and press # when prompted.
3. Enter the four-digit password and press
# when prompted. (The factory-set password is
1234.)
The first time you access this menu, you should change the factory-set password. Use a hard-to-guess
value, and record it in a safe place. See “Changing the System Manager’s Password.”
To Next Page
Loading...
Need help?
General