LUMINELL SL2 - DIM Adjustment

INSTALLATION & USER'S MANUAL SL2 Page 37
Dim adjustment
LED lamp dimming is controlled from the operator panel in fixed steps according to below
illustration, no visible indication of selected dim level in the operator panel display.
Spot LED intensity levels are 20% - 40% - 60% - 80% - 100%.
Increase
Decrease
Press button (3) to activate the spot sector on both LED modules (above in yellow).
Flood LED intensity levels
20% - 40%
60% - 40% - 80% - 100%
Press button (3) to activate the spot sector on both LED modules (above in yellow).
When light intensity above 40% is selected then the spot beam will fill up with low intensity
light to avoid a dead area in beam center.