INSTALLATION & USER'S MANUAL SL2 Page 85
USING THE THERMAL CAMERA IN CAM MODE
Activate the thermal camera
Note:
● Make sure your monitor is powered on before activating the camera.
● Activation takes a few seconds, don’t press any cam-buttons until the image is visible in
the monitor.
● During each camera-activation, configuration data is sent to the camera and the image
will flash for a second and then become stable, this is a completely normal start-up
phase for the camera.
● Changes in CAM mode takes effect immediately and does not require confirmation.
● Camera settings can only be accessed if camera is activated.
● Activation must be done from the CAM-mode screen.
● Activated camera is indicated by the letter “C” in the bottom left of the display.
To activate the camera, first select "Surveillance” from the quick start menu.
In “Surveillance” submenu, select "CAM mode”.
To Next Page
Loading...
