LUMINELL SL2 - Warranty Conditions Sl2

Page 8 INSTALLATION & USER'S MANUAL SL2
WARRANTY CONDITIONS SL2
Luminell General Terms and Conditions can be found on our website www.luminell.com.
These terms govern the contractual relationships between Luminell and the Purchaser.
In the event of any conflict between this document and our General Terms and Conditions, the
General Terms and Conditions shall take precedence.
Warranty period
LUMINELL offer a warranty for the following products:
- LED-based lamps: warranty period: 60 months
- HMI-based lamps: warranty period: 24 months
- Spare parts: warranty period: 12 months
Warranty period starts from the date the goods is shipped from LUMINELL factory.
Product specific conditions
A correctly installed searchlight system from Luminell requires no planned regular maintenance
or service other than regular cleaning and care during the first 10 years of operation.
The “Maintenance and Service plan” describes how to keep the product in good condition.
The warranty is conditioned by below mentioned key points.
Before powering up the unit, make sure that:
 Vibration dampers are mounted correctly according to this installation manual.
 The mechanical fundament where the searchlight is placed is robust.
 Warranty seal on the service hatch is unbroken.
 Outgoing cable radius from the searchlight is smooth and not stressed.
 All cables used for the installations are as per Luminell’s specifications or as per
separate made agreement.
 Signal cables are not placed together with high power cables.
 Electrical connections are made according to electrical scheme and wiring diagram.
 Length of cables are not exceeding the recommended maximum lengths as stated
below:
• Power/signal cables between searchlight and E-box for 100-240VAC-system: Max
30 meter
• Power cables between searchlight and E-box for 24 VDC-system: Max 7 meter
• Remote cable / Ethernet cable between E-box and remote control: Max 100 meter
(longer distance requires an amplifier or fibre optic version).
 E-box (EB) is placed in a non-condense environment with a minimum temperature of +5
C (indoor) if not customised for other installation.
 The remote panel (OP) is bridge mounted in an IP56 environment. If placed outside, it
must be under a protection hood when not in use.
 Remote panel is screwed in bridge panel, properly grounded and correct installed.
After above checkpoints are verified the system should be started up as per this manual
to verify the functionalities.
In case of any questions related to the warranty, please contact us at
service.sweden@luminell.com for additional support.