LUMINELL SL2 - Factory Setup, How to Change between PAL and NTSC

Page 84 INSTALLATION & USER'S MANUAL SL2
Factory setup, how to change between PAL and NTSC.
In the systems hidden installation menu, named "Factory setup" it is possible to choose
between the two different video standards. Your monitor may be compatible with only NTSC or
only PAL or both. See your product manual for detailed info.
Follow these steps to boot the system in “Factory Setup”-mode.
1. If the system is powered up, turn it off by turning the main switch to "0".
2. Press all three buttons on cabinet card while turning the main switch to "1", keep
pressing until the text "Factory Setup" appears on the display.
3. Repeatedly press the “Right” button until the submenu "0.9 Set Camera" appears in the
display. Press the “OK” button to enter this menu.
4. With the “Right” button you can step through the following settings:
• Camera Off: disables the possibilities to control the camera from the operator panel, do
not select this if you have a SL-IR unit.
• Camera PAL: Sets video output to PAL (25Hz) when cam is activated.
• Camera NTSC: Sets video output to NTSC (30Hz) when cam is activated.
When preferred setting is displayed, Press “OK” to save, submenu "0.9 Set Camera" is shown.
5. Now press the “Down” button once, menu "1. About" appears in the display.
6. Setup complete, recycle power on main switch.