Lynx BRP REX2 Adventure LX 600 ACE User Manual

MAINTENANCE PROCEDURES
Recommended Engine Coolant
COOLANT
BRP
recommended
product
LONG LIFE
ANTIFREEZE(F)
(P/N 619 590 204)
Alternative, or
if not available
Distilled water and
antifreeze solution
(50% distilled water,
50% antifreeze)
NOTICE
A blend of 50% antifreeze
with 50% distilled water will im-
prove the cooling efficiency. Using
water ta p instead of distille d water,
would contribute to make deposits
in cooling system and to reduce an-
tifreeze efficiency. This could lead to
engine overheating.
To prevent antifreeze deterioration, al-
ways use the same brand. Never mix
different brands unless cooling system
is completely flushed and refilled.
NOTICE
To prevent rust formation
or freezing condition in cold areas,
always replenish the system with
50% antifreeze and 50% distilled wa-
ter. Pure antifreeze will freeze at a
higher temperature than the opti-
mal water/antifreeze m ix. Always
use ethylene glycol antifreeze con-
taining corrosion inhibitors specif-
ically recommended for aluminum
engines.
Engine Oil
Recommended Engine Oil
E-TEC Models
Refer to INJECTION OIL subsection
for detailed information.
ACE Models
ENGINE
RECOMMENDED
ENGINE OIL
600 and
900 ACE
XPS 4-STROKE
SYNTHETIC OIL (F)
(P/N 619 590 114)
NOTICE
The engine of this snow-
mobile has been developed and val-
idated using the recommended BRP
XPS™ oil. BRP recommends the
use of its recommended XPS oil or
equivalent. Damages caused by oil
which is not suitable for this 4-stroke
engine will not be covered by the
BRP lim ited warranty.
If the recommended oil is not avail-
able, use SAE 0W-40 synthetic-based
oil that meets or exceeds the require-
ments for API service classification
SM.
Engine Oil Level Verification
NOTICE
Check level every 10
hours of use and refill if necessary.
Do not overfill. Operating the en-
gine with an improper level may
severely damage engine. Wipe off
any spillage.
Make sure the engine is at normal oper-
ating temperature.
NOTE: The engine reaches normal
temperature when the rear radiator
gets warm indicating the thermostat
has opened.
Place vehicle on a level surface and
proceed as follows to check oil level:
1. Let engine run at idle for approxi-
mately 30 seconds.
2. Stop engine.
3. Open the LH side panel, refer to
CONTROLS, INSTRUMENTS AND
EQUIPMENT
.
4. Remove the drive belt guard, re-
fer to
CONTROLS, INSTRUMENTS
AND EQUIPMENT
.
______________
103

Lynx BRP REX2 Adventure LX 600 ACE Specifications

General

Brand	Lynx
Model	BRP REX2 Adventure LX 600 ACE
Category	Snowmobiles
Language	English