MONITORING SYSTEM
NOTE: Some of the listed pilot lamps do not apply to all models. The message dis-
play is available only on the multifunction analog/digital gauge.
PILOT
LAMP(S)
ON
BEEPER
MESSAGE
DISPLAY
DESCRIPTION
4short
beeps
every
5
minutes
LOW OIL
E-TEC: Injection oil level is low. Stop vehicle
in a safe place then, replenish injection oil
reservoir.
ACE: Low engine oil pressure. Stop vehicle in
a safe place then, check oil level. Fill to proper
level. If oil level was correct, discontin ue use
and contact an authorized Lynx dealer.
ENGINE
OVERHEAT
Engine is overheating, reduce snowm obile
speed and run in loose snow or stop engine
immediately and let engine cool down. Check
coolant level, refer to
MAINTENANCE
.If
coolant level is correct and overheating
persists, contact an authorized Lynx dealer.
Do not run the engine if condition persists.
4short
beeps
every 30
seconds
MUFFLER
Reduce speed or stop engine. Let engine cool
down and restart. If overheating persists,
contact an authorized Lynx dealer. Do not run
the engine if condition per sists.
ENGINE
OVERHEAT
Critical overheat. Stop engine immediately
and let e ngine cool down. Check coolant
level, refer to
MAINTENANCE
. If coolant level
is correct and overheating persists, contact an
authorized Lynx dealer. Do not run the engine
if condition persists.
MUFFLER
OVERHEAT
Short
beeps
repeating
rapidly
ECM OVERHEAT
E-TEC: Critical overheat. Stop engine
immediately and let engine cool down. If
overheating persists, contact an authorized
Lynx deale r. Do not run the engine if condition
persists. Do not run the engine if condition
persists.
LOW BAT
4short
beeps
every
5
minutes
HIGH BAT
Indicate a low or high battery voltage
condition. See an authorized Lynx dealer as
soon as possible.
4short
beeps
CHECK ENGINE
Engine fault, see an authorized Lynx dealer as
soon as possible.
148
______________
To Next Page
Loading...
Need help?
General
