MONITORING SYSTEM
PILOT
LAMP(S)
ON
BEEPER
MESSAGE
DISPLAY
DESCRIPTION
—
Displayed when brake is applied for more than
15 seconds w hile throttle lever is squeezed
and vehicle is moving at more than 5 km/h
(3 MPH).
—
4short
beeps
every
5minutes
KNOCK
E-TEC: Engine deto natio n (RPM is limited
when this condition occurs).
– Ensure recommended fuel is used.
– Check fuel quality, replace if
necessary.
– If fault still occurs, contact an
authorized Lynx dealer, repa ir shop,o r
person of your own choosing.
—
4short
beeps
every
5
minutes
REV LIMIT
Engine RPM limited for protection when
certain faults occur.
——
OVER REV
On E-TEC engines, indicates that maximum
engine RPM is reached. Check clutch
calibration.
—
Short
beeps
repeating
rapidly
SHUTDOWN
Shutdown procedure in force due to engine
overheating or fuel pump problem, remove
tether cord cap from engine cut-off switch
and contact an authorized Lynx dealer.
——
COMMUNICATION
Communication problem be twe en E CM and
gauge. Stop eng ine, remove tether cord cap.
Wait a few minutes, then start engine. If
problem persists, contact an authorized Lynx
dealer
2short
beeps
—
Good key, vehicle ready to operate.
2short
beeps,
repeating
slowly
CHECK KEY
Unable to read key (bad connection). Make
sure the key is clean and correctly snapped on
post.
DESS
Short
beeps
repeating
rapidly
BAD KEY
Invalid key or key not programmed. Use
the proper key for the vehicle or have the
programmed.
______________
149
To Next Page
Loading...
Need help?
General
