Select a Sound
To select a new sound, turn the Data Control knob until the
desiredsoundisshownintheLEDdisplay.
Turn the Data Control knob to select a voice.
Below is a list showing the eight sounds built into the DCP-200
piano, as well as the way the voice names are abbreviated for
theLEDdisplay.
Turning the Data Control knob
clockwise scrolls down the list
(ultimately stopping at Upright Bass),
while turning the Data Control knob
counter-clockwise scrolls up the list
(ultimately stopping at Grand Piano).
Note that the sound selections do not
repeat in an endless loop if you keep
turning the Data Control knob in one
direction.
To Next Page
Loading...
