M-Audio DCP-200 - Method 2: Factory Reset

User Guide14 DCP-200
Method 2: Factory Reset
Performing a Factory Reset will clear all battery backed memory and restore all functions to their
factorydefaults,justliketheywerewhenyouusedDCP-200forthersttime.Pleasenotethatanything
you have recorded in the Song Recorder will be erased by this procedure!
‣ To do a Factory Reset:
Turn the Power Off.
Hold down the Reverb and Voice/Function buttons while powering
on DCP-200.
   TheLEDDisplaywilllightALLsegments,andallLEDsonthedevicewilllightwhilethese
buttons are held down. Once this has happened, you can release the Reverb and
Voice/Function buttons.
When the Reverb and Voice/Function buttons are released, DCP-200 will return to
PerformanceMode(ready-to-play).AllbuttonLEDswillreturntotheirdefaultstates.TheLED
Displaywillshowtheversionnumberofthermware(thepiano’sinternaloperatingsoftware)
for 2 seconds and then return to showing the Voice Name (Grand Piano - Pno).
   DCP-200willthenfunctionnormallyandasifpoweredonforthersttime.
2
1
ON / OFF
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
-r-
MASTER VOLUME
+
ON / OFF