M-Audio DCP-200 - Layer Mode Operations

User Guide 35DCP-200
Layer Mode
In Layer Mode, DCP-200 will play two voices simultaneously on each key.
‣ To use Layer Mode:
PresstheVoice/FunctionbuttontoenterEditMode.
2. Press and hold down a Voice Select key
(any white key in the lowest octave of the
piano). This will select the Main Voice. (See
the section on Using the Voice Select Keys
at
thebeginningoftheEditModeFunctions
section for more information on selecting
voices in this manner.)
     3. WhilecontinuingtoholdtherstVoice
Select key, press a second Voice Select key.
This will select the Layer Voice.
While both keys are held down the display
will show:
      
< DCP-200 is now in Layer Mode. Both the Main and Layer Voices will sound when keys are pressed.
(Intheexampleillustration,BrightPianoistheMainVoice(becauseitisselectedrst),andStrings
is the Layer Voice (because it is selected second).
 < If the Data Control knob is used to change voices while in Layer Mode, it will affect the Layer Voice
only. The Main Voice (original voice) will stay the same until Layer Mode is turned off again.
 < Please note that polyphony may be reduced while Layer Mode is in use.
1
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
PNo
MASTER VOLUME
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
LYR
Grand Piano
Bright Piano
Vintage EP
FM EP
Church Organ
Harpsichord
Strings
Upright Bass
2 3