M-Audio DCP-200 - Using the Metronome

User Guide18 DCP-200
Using the Metronome
DCP-200 features a built-in metronome which can be used for practicing to a set tempo, and is also helpful
when recording tracks in the Song Recorder.
To Activate the Metronome:
Press the Metronome button.
The
metronomewillsoundahightoneontherstbeatofabar,
and a lower tone on the remaining beats of the bar. The Metronome
button’sLEDwillalsoashintime.
Metronome Volume
The metronome volume can be raised or lowered to a level that is comfortable for you.
‣ To change the metronome’s volume:
Press the Voice/Function button on the left hand panel.
Press the Metronome Volume key (C#1)
on the keyboard.
       TheLEDdisplaywillmomentarily
show
M
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
PNo
1
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
PNo
2
MASTER VOLUME
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
MtR
C#1
C0
Did you know...
...that many of the keys on your keyboard allow you to access
additional features on DCP-200? Push the Voice/Function
button to activate this mode (called Edit Mode), and then use
the included A4 laminate sheet to locate the keyboard key that
gives access to the feature you are looking for. Instructions on
how to use specic features while in Edit Mode can be found
throughout this manual. A comprehensive explanation of the
features in Edit Mode can be found in the Edit Mode section
later in this User Guide.