7 Edit Mode
InEditMode,thekeysontheDCP-200pianokeyboarddonotmakeanysound.Instead,thekeysareused
for selecting functions for editing. In most cases, an edit function is selected using the keyboard, and the Data
Control
knobisusedtoincreaseordecreasethevalueoftheselectededitingparameter.ToenterEditMode,
press the Voice/Function button.
Included with your piano is an A4 laminate sheet which shows the locations of all the special function keys.
Please keep it at hand for reference. The chart below is a smaller version containing the same information.
Resetting the Data Control Knob to Voice Select
Whenever you power up DCP-200, the Data Control knob is assigned to instantly select sounds (Voice Select)
at a turn of the knob. However, when using other DCP-200 features, you will often have occasion to assign the
Data Control knob for other uses. Although the Data Control knob can easily be returned to its Voice Select
function as part of a Piano Reset, here is another way to change the Data Control knob back so that it can be
used for selecting sounds:
Press the Voice/Function button. It will light up.
PressthekeyEb2.TheLED
will momentarily display
SEL,
andwillthendisplay
the currently selected
sound. Now you can use
the Data Control knob to
select sounds as
before.
‣ NOTE: No matter how the Data Controller knob is assigned, you can always select sounds
(in Performance Mode) by holding down the Voice /Function button while turning the
Data Control knob.
To Next Page
Loading...
