13 Appendices
Appendix A — Defaults
At power up, the DCP-200 piano is in Performance Mode, with the Data Control knob set to Voice Select.
Default Settings
The table below shows the DCP-200 factory default settings and whether or not user changes to these
settings are retained after a power-cycle (turning the device off and on):
Parameter Factory Default Retained on Power-Down
Program Number & Voice Selected 000 - Grand Piano No
Bank MSB Number 000 No
Bank LSB Number 000 No
Main MIDI Transmit Channel Channel 1 No
Octave shift 0 No
Transpose 0 No
Local On No
Data Control Assignment Data = Voice Select No
Reverb On/Off Reverb On Yes - store for each sound
Reverb Depth Defaults for each sound Yes - store for each sound
Velocity Curve Selected ‘NORMAL’ Yes
Split Point Eb3 Yes
Voice Volume 127 No
Layer Volume 100 Yes
Split Volume 127 Yes
Metronome Volume 127 Yes
Master Tune 0 Yes
Tempo 120 Yes
Layer Mode Voice n/a n/a
Split Mode Voice 8 - Upright Bass Yes
Layer Mode On/Off Off No
Split Mode On/Off Off No
At power-on, the following MIDI data will be sent to the sound engine, the USB MIDI and the MIDI Out:
1. Bank Change MSB=0, LSB=0, PGM=0 - Set sound engine to piano voice
2. Reverb default value
To Next Page
Loading...
