M-Audio DCP-200 - Master Tuning (F#2)

User Guide 41DCP-200
Master Tuning (F#2)
 PressingthiskeywillsettheDataControlknobtoraiseorlower(“ne-tune”)theMasterTunesetting
of DCP-200.
PresstheVoice/FunctionbuttontoenterEditMode.
Press the Master Tuning key (F#2).
   TheLEDdisplaywillmomentarilyshow

.
Use the Data Control knob to set the Master Tuning.
  TheLEDdisplaywillshowapositive,negative,orzero
value between -64 and 64.
Of course, DCP-200 never actually “goes out of tune,”
but the Master Tuning feature can be useful when you are
playing along with another instrument or recording that
may be slightly above or below standard pitch.
1
2
3
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
PNo
MASTER VOLUME
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
tUN
C0 C1 C2
F#2
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
-10
‣Remember: No matter how the Data Control knob
is assigned, you can always select sounds (in
Performance Mode) by holding down the Voice /
Function button while turning the Data Control knob.