M-Audio DCP-200 - Piano Reset; Additional Default Information

User Guide 71DCP-200
Piano Reset
As soon as the Piano Reset function is activated (by pressing the Reverb and Voice/Function buttons
simultaneously), the device will perform the following functions:
1. Turn Local On
  2. Send
‘AllNotesOff’CommandonMIDIChannel1-externalandtotheinternalsoundengine
  3. Send‘ResetAllControllers’CommandonMIDIChannel1-externalandtotheinternalsound
engine
4. Assign Data Control to Voice Select
5. Set Volume levels for Main Voice, Split Voice and Layer Voice to defaults
6. Set Pan to 64 for Main Voice, Split Voice and Layer Voice
7. Turn off Layer Mode and Split Mode
8. Set Main MIDI Transmit Channel to 1
9. Set Transpose and Octave Shift both back to zero
10. Send a Program Change = 0 on Channel 1
11. Send a Bank Change MSB = 0 and Bank Change LSB = 0 on Channel 1
12. Set the Reverb Depth back to the default value for the Default Voice
13. Send Chorus Depth = 0 on Channel 1
14. Send the current status of the Sustain Pedal on Channel 1
Additional Default Information
‣ Reverb Defaults
PGM Sound Name Reverb On/Off Reverb Depth
0 Grand Piano On 40
1 Bright Piano On 40
2 VintageEP On 40
3 FM
EP On 48
4 Church Organ On 96
5 Harpsichord On 40
6 Strings On 64
7 Upright Bass On 32
MIDI Channel 10 (Metronome) Off n/a 0
‣ Other Defaults
Parameter Default Value Range
Octave Shift 0 -3 to +3
Transpose 0 -12 to +12
Voice Vol 127 0 to 127
Layer Vol 90 0 to 127
Split Vol 127 0 to 127
Metronome Vol 127 0 to 127
Tempo 120 20 to 280 bpm
Program 0 0 to 127
Bank LSB 0 0 to 127
Bank MSB 0 0 to 127
Channel 1 1 to 16
Voice Select 1 (Grand Piano) 1 to 8 (display shows Voice names)
Tuning 440
Hz(displayshows‘0’) -64 (-50 cents) to 63 (+50 cents) in 128 MIDI steps
6
6
1 tone = 100 cents, therefore -50 to +50 cents = -1 to +1 semi-tone.
Note this is shown in MIDI steps -64 to 63.