M-Audio DCP-200 - Using the Built-In Reverb

To Next Page

To Previous Page

User Guide 15DCP-200

Using the Built-in Reverb

Your DCP-200 piano includes a built-in digital Reverb that can be used for adding a natural-sounding room

ambience to any of the piano’s eight voices.

To apply Reverb to a voice:

Press the Reverb button. The button will illuminate, and you will

hear the Reverb effect when you play the currently selected voice.

ToturnReverboff,presstheReverbbuttonagain.ThebuttonLED

will turn off to indicate that Reverb is no longer active.

To adjust the Reverb depth (Reverb amount):

 1. PressandholdtheReverbbutton;theLEDdisplaywill

change to show the current Reverb depth.

2. While holding the Reverb button, turn the Data Controller

knob (7) to adjust the reverb depth setting. The minimum

setting is 0, and the maximum setting is 127.

Once you have the desired amount of Reverb, let go of the

Reverb button, and resume playing DCP-200.

  Eachoftheeightbuilt-invoiceswillrememberits

individual Reverb on/off status and depth setting, even

after turning the Power switch off and on.

Reverb

Song

RECORD

Data Control

[Assignable]

Metronome

Voice / —

Function

MASTER VOLUME

PNo