M-Audio DCP-200 - Page 59

User Guide 59DCP-200
‣ To assign the Data Control knob to send MIDI Program Changes:
 PresstheVoice/FunctionbuttontoenterEditMode.
Press the Program
Number Data
Control Key (F#1).
3
           TheLEDdisplay
will momentarily
show

.
3
Note that this is different than the Program Key (F#5) that you used to input a single MIDI Program
Number value.
Now you are back in Performance Mode, and the Data Control
knob has been assigned so that a MIDI Program Change will be sent
out
eachtimethecontrolisturned.TheLEDdisplaywillshowthe
currently selected MIDI Program Number (between 0 and 127).
1
2
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
pNo
MASTER VOLUME
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
PGM
C0 C1 C2
F#1
3
Reverb
Song
RECORD
Data Control
[Assignable]
Metronome
Voice / —
Function
22