User Guide62 DCP-200
‣ To assign the Data Control knob to send Bank LSB changes:
PresstheVoice/FunctionbuttontoenterEditMode.
Press the Bank LSB
Data Control Key
(Ab1).
4
TheLEDdisplay
will momentarily
show
4
Note that this is different than the Bank LSB Key (Ab5) that you used to input a single Bank LSB value.
Now you are back in Performance Mode, and the Data Control knob
has been assigned to send Bank LSB values.
A MIDI Bank LSB change will be sent out each time the Data
Controlknobisturned.TheLEDdisplaywillshowtheBankLSB
value (between 0 and 127) as you turn the knob.
1
2
3
To Next Page
Loading...
