To Next Page

To Previous Page

Page 15

5.20 Program Function Relay 2 / K26 Relay (RX)

1) Press “→” button to enter Function Relay 2 setting.

2) Press “↑” and “↓” button to scroll and select.

3) Exit Program Function Relay 2 by pressing the “BACK” button until the

cursor is shown next to “FUNC RLY2”.

4) Press “↑” and “↓” button to scroll through other Flex EX2 settings.

--- : START function only.

LV : Function relay closes when receiver voltage is low.

ID : Function relay works simultaneously with all motion commands.

NORMAL : START function + AUX with normal momentary output.

TOGGLE : START function + AUX with toggled/latching output.

TOG&E : START function + AUX with toggled/latching output. The relay opens when

STOP button is pressed down and transmitter power off.

S/P : FUNCTION relay closes when START command is executed and opens only when

transmitter power is turned off.

EXT : FUNCTION relay works simultaneously with the receiver MAIN relays.

TDM A+B : FUNCTION relay closes when selector switch is rotated to the A+B position

and opens when rotate to A or B positions (tandem monitoring output).

HORN : FUNCTION relay closes for up to 3 seconds when START command is initiated

at transmitter power on and then becomes normal momentary outputs thereafter.

G SENSOR : FUNCTION relay closes when Zero-G sensor is triggered (receiver MAIN

relays deactivated) and opens when receiver MAIN relays are reactivated.

RS : For RS system, the function relay works simultaneously with the Select pushbutton.

5.21 Program Function Relay 3 / K30 Relay (RX)

1) Press “→” button to enter Function Relay 3 setting.

2) Press “↑” and “↓” button to scroll and select.

3) Exit Program Function Relay 3 by pressing the “BACK” button until the

cursor is shown next to “FUNC RLY3”.