Page 38
6.43 Program SW5 Output Relay (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter SW5 Output Relay setting.
3) Press “→” button and then “↑” and “↓” button to select “LOCK” or “UNLOCK”.
4) Press “BACK” button to go back to step 3.
5) Press “↓” button and then “→” button select SW5 Output Relay function.
6) Press “↑” and “↓” button to scroll and select.
7) Exit Program SW5 Output Relay by pressing the “BACK” button until the
cursor is shown next to “SW5 RLY”.
8) Press “↑” and “↓” button to scroll through other Flex 2JX settings.
UNLOCK Settings (SW5 and SW4 output relays not interlocked):
Select “NORMAL” the output relay becomes momentary contact.
Select “NORMAL+S” the output relay becomes momentary contact. Must press the green
START button together to work.
Select receiver “TOGGLE” the output relay becomes toggled contact.
Select receiver “TOGGLE&E” the output relay becomes toggled contact affected by the e-stop
command (output relay opens when e-stop button is pressed).
Select “PITCH” SW5 button becomes the “Pitch” function in Pitch & Catch Operation.
Select “PITCH&E” SW5 button becomes the “Pitch” function in Pitch & Catch Operation. When
Pitch command is initiated the receiver mains are disconnected.
Select “STOP” SW5 button becomes an auxiliary e-stop function. Press to disconnect the
receiver mains and press START button to reconnect the receiver mains.
Important note 1: When one of the above is selected make sure the same SW5 button function
on transmitter is set to “NORMAL”.
Important note 2: When select Pitch & Catch function make sure you set the spare transmitter
to the next channel up and the receiver channel scanning to “02”.
Select ABUS (reversed logic A/B switching) all contacts are reversed when all pushbuttons,
rocker switches and rotary switches are set to A/A+B/B function.
LOCK Settings (SW5 and SW4 output relays interlocked):
Select “NORMAL” both output relays become interlocking momentary contacts.
Select receiver “TOG/TOG” both output relays become interlocking toggled contacts.
Select receiver “TOG/TOG&E” both output relays become interlocking toggled contacts affected
by the e-stop command (output relay opens when e-stop button is pressed).
Select “ON/OFF” both output relays become interlocking On and Off contacts.
Select “ON/OFF+S” both output relays become interlocking On and Off contacts. Must press
the green START button along with the On or Off button to work.
Select “ON/OFF&E” both output relays become interlocking On and Off contacts affected by the
e-stop command (output relay opens when e-stop button is pressed).
Select “MAGNET” the two output relays become interlocking Magnet ON and OFF contacts.
Important note: When one of the above is selected make sure the same SW5 and SW4 button
function on transmitter are both set to “NORMAL”.
To Next Page
Loading...
Need help?
General
