Page 75
9.51 Program PB9 Ramp (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter PB9 Ramp setting.
3) Press “↑” and “↓” button to scroll and select “ACC” for acceleration and
“DEC” for deceleration and press “→” button to enter.
4) Press “↑” and “↓” button to change value.
5) Press “BACK” button to go back to step 3.
6) Exit Program PB9 Ramp by pressing the “BACK” button until the cursor is
shown next to “PB9 RAMP”.
7) Press “↑” and “↓” button to scroll through other Flex EP-H settings.
9.52 Program PB10 Ramp (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter PB10 Ramp setting.
3) Press “↑” and “↓” button to scroll and select “ACC” for acceleration and
“DEC” for deceleration and press “→” button to enter.
4) Press “↑” and “↓” button to change value.
5) Press “BACK” button to go back to step 3.
6) Exit Program PB10 Ramp by pressing the “BACK” button until the cursor is
shown next to “PB10 RAMP”.
7) Press “↑” and “↓” button to scroll through other Flex EP-H settings.
9.53 Program PB11 Ramp (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter PB11 Ramp setting.
3) Press “↑” and “↓” button to scroll and select “ACC” for acceleration and
“DEC” for deceleration and press “→” button to enter.
4) Press “↑” and “↓” button to change value.
5) Press “BACK” button to go back to step 3.
6) Exit Program PB11 Ramp by pressing the “BACK” button until the cursor is
shown next to “PB11 RAMP”.
7) Press “↑” and “↓” button to scroll through other Flex EP-H settings.
9.54 Program PB12 Ramp (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter PB12 Ramp setting.
3) Press “↑” and “↓” button to scroll and select “ACC” for acceleration and
“DEC” for deceleration and press “→” button to enter.
4) Press “↑” and “↓” button to change value.
5) Press “BACK” button to go back to step 3.
6) Exit Program PB12 Ramp by pressing the “BACK” button until the cursor is
shown next to “PB12 RAMP”.
7) Press “↑” and “↓” button to scroll through other Flex EP-H settings.
To Next Page
Loading...
Need help?
General
