EC-30C | 1.00.02 +49 2102 935 888 www.mc-techgroup.com 9
When replacing parts, use only original M&C spare parts.
Pull Main
Plug!
If there is any indication that safe operation of the EC-30C is no
longer possible, turn off the power and disconnect the device from
the power supply immediately.
Then protect the defective device against accidental switch-on and mark it clearly as
defective.
2.5 Working on electrical and electronic devices
Only qualified and authorized personnel are permitted to work on equipment which op-
erates on 115 or 230 VAC supply voltage. Please be sure to observe the generally accepted
engineering standards and all of your national and local regulations.
Note
Before connecting the device, please make sure that the supply
voltage matches the specified voltage on the product label.
High
Voltage!
Protect yourself and others against damages which might be caused
by high voltages. Disconnect the power supply before opening the
device for access. Make sure that all external power supplies are
disconnected.
Please make sure to take appropriate precautions even by working on unplugged or
low-voltage devices. Unplugged devices need to be properly grounded to prevent dam-
age to internal electronics from electrostatic discharges (ESD).
2.6 Not certified in hazardous areas
This device is NOT certified to be installed or operated in hazardous areas.
WARNING
Explosion hazard!
For general purpose areas ONLY. Don’t use the EC-30C in hazardous
areas.
To Next Page
Loading...
