Manitou AETJ 43 - Compensation;Tilting Circuit - Pressure Setting; Decompression of the Circuit; Valve a Adjustment

HYDRAULIC
50
70
547379EN
70 (08/03/2017)
70.3.5 COMPENSATION/TILTING CIRCUIT  PRESSURE SETTING
DECOMPRESSION OF THE CIRCUIT
- Decompression of the compensation/
tilting circuit (6COMPENSATION/TILTING CYLINDER REMOVAL, 5 64)
- Switch o the power to the access platform.
VALVE A ADJUSTMENT
(17, 070.1.1), (19, 070.1.2)
- Place a Tee connector on the by-pass at outlet A5 (1, 070  18) and
connect the pressure gauge (2, 070  18).
- Switch on the access platform.
- Follow steps (1, 070  20), (2, 070  21) and (3, 070  22): the
verification of the setting of valve A (1, 070  19) and its
adjustment are to be carried out during movement 3.
0
A5
70 - 18
2
1
70 - 19
1
70 - 20
TO ITS FULL
EXTENT
1
70 - 21
TO ITS FULL
EXTENT
2
70 - 22
3