Manitou AETJ 43 - Electricity Removals - Refitting; Variable Speed Controllers - Removal

ELECTRICITY
136
80
547379EN
80 (08/03/2017)
80.4 ELECTRICITY REMOVALS  REFITTING
80.4.1 VARIABLE SPEED CONTROLLERS  REMOVAL
- Raise arm 1/2 so that the upper hinge (1, 080 - 120) is raised by
1m (39.37 in).
-Turn the turret by 1/4 turn (2, 080 - 120).
- Switch o the power supply.
- Disconnect the right-hand battery:
- Remove the right-hand battery protective cover (4, 080 - 120).
- Disconnect the - earth (1, 080 - 121).
- Disconnect the + (2, 080 - 121).
- Disconnect the left-hand battery, following the same procedure.
- Remove the cover (4, 080 - 120).
- Remove the cover plate (1, 080 - 122).
- Mark and then remove the harnesses connected to the variable
speed controllers (2, 080 - 122) (680.3.4 VARIABLE SPEED CONTROLLERS
 CONTROL AND SETTINGS, 5 115)
- Remove the variable speed controllers.
80 - 120
4
1
3
2
80 - 121
1
2
80 - 122
2
2
1