Manitou AETJ 43 - 30.1.1 Rear Axle - Operation in Freewheel Mode

27
AXLE
30
547379EN
30 (08/03/2017)
AXLE
30.1 CHARACTERISTICS AND SPECIFICATIONS
30.1.1 REAR AXLE  OPERATION IN FREEWHEEL MODE
DANGER
In order to operate the access platform in freewheel mode, it should not be subjected to translational
constraints resulting from a slope.
When the access platform is in the freewheel mode, it can move freely: t wedges to immobilize the wheels.
CAUTION
If the access platform needs to be towed, this operation should only be carried out:
- Over short distances.
- Necessarily by a machine that has high braking power in order to hold it steady, and at a slow speed.
- By means of a connecting bar between the two machines.
- IF POSSIBLE, lift the rear of the platform (1, 030  4).
3 120 AETJL : 2680 kg (5908 lbs)
3 150 AETJC : 3770 kg (8311 lbs)
3 150 AETJL - 150 AETJC 3D : 3375 kg (7441 lbs)
3 170 AETJL - AETJ49 : 3842 kg (8470 lbs)
3 AETJ43 - AETJ43 3D : 3775 kg (8322 lbs)
- Locate the screws (2, 030  4).
- Unscrew these screws according to the model of your platform,
030  5) by 22 mm (0.87 in), up to the hard spot and without forcing:
RISK OF BREAKAGE.
2 Maximum loosening torque 20 N.m (177 lb-in).
- Set the platform down.
- The machine can now be towed.
RESETTING
- Raise the rear of the platform.
- Turn the wheels from left to right and reset the gears by re-
tightening the screws (2, 030  5):
2 Maximum tightening torque for rear wheel 150 N.m (1327.6 lb-in)
30 - 4
2
2
1
15 daNm
2 daNm
22 mm
150 N.m
20 N.m
22 mm
30 - 5
2
1