“PREMIUM” DRIVER'S PNEUMATIC SEAT
DESIGNED FOR MAXIMUM COMFORT, THIS SEAT CAN BE ADJUSTED AS FOLLOWS.
WEIGHT ADJUSTMENT (FIG. A)
Adjust the weight when the driver is sitting on the seat.
-Pull the weight adjustment lever 1 fully out.
-Move the weight adjustment lever 1 up to increase the weight or down to reduce it.
- The driver's weight is correctly adjusted when the arrow is in the centre of indicator 2.
- After completing weight adjustment, fully lower the lever 1.
NOTE: To avoid any health problems, it is recommended to check and adjust the
weight setting before starting the lift truck.
LONGITUDINAL ADJUSTMENT (FIG. B)
IMPORTANT
Only operate the lever by its recessed section and do not grasp from below, at the risk of crushing the hand.
- Adjust the locking lever until you reach the position required. This then locks and
the seat will not shift into another position.
LUMBAR ADJUSTMENT (FIG. C)
This increases the comfort of the seat and the driver’s freedom of movement.
- Turn knob to 1 to adjust the height and depth of the lumbar support of the upper
part of the back-rest.
- Turn knob to 2 to adjust the height and depth of the lumbar support of the lower
part of the back-rest.
ANGLE ADJUSTMENT OF THE BACK-REST (FIG. D)
IMPORTANT
If you do not support the back rest when making adjustments, it will tilt forwards.
- Support the back-rest, pull the lever and position the back-rest to find the desired
position.
MAINTENANCE
- Keep your seat clean to ensure it operates efficiently
- Clean the cushions using a suitable product.
- Apply to a small hidden area first, to check the colour-fastness of covering.
- Avoid wetting the cushions.
2-42
A
B
C
D
647690 (29/01/2019)
To Next Page
Loading...
