EasyManuals Logo

Manitou MC 25-2 D K ST3A S1 User Manual

Manitou MC 25-2 D K ST3A S1
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
CHECK Coolant level
Place the lift truck on level ground with the engine stopped, and allow the engine to cool.
IMPORTANT
To avoid any risk of spraying or scalding, wait until the engine has cooled down before removing the cooling system
filler plug.
In the event of an emergency, it is possible to use water as the coolant, but then replace with coolant as quickly as
possible (
2,000 H - PERIODIC SERVICE).
- Open the engine cover ( COMMAND AND CONTROL INSTRUMENTS).
- The liquid must be at the MAXIMUM level on the expansion tank 1.
- If necessary, add coolant (
LUBRICANTS AND FUEL)
.
- Add coolant via filler port 2.
- Visually check that there is no leakage in the radiator and pipes.
CHECK Fuel level
As far as possible, keep the fuel tank well filled in order to reduce condensation.
- Remove cap 1.
- Fill the fuel tank with clean fuel (
LUBRICANTS AND FUEL), filtered through a
strainer or a clean, lint free cloth, through filler port 2.
- Put the cap 1 back.
- Visually check that there is no leakage in the tank and pipes.
IMPORTANT
Never smoke or approach with a flame during filling operations or when the tank is open.
Never refill while engine is running.
The fuel tank is degassed via the filling hole. When changing it, always use an original plug with a degassing hole.
CLEAN Cyclonic pre-filter (option)
The frequency of cleaning is given as an example. However, as soon as impurities reach
the MAX level on the tank, the pre-filter must be emptied and cleaned.
IMPORTANT
When cleaning, take care not to let impurities into the dry air filter.
- Loosen nut 1 remove cover 2 and empty the tank.
- Clean the pre-filter unit with a clean dry cloth.
- Refit the unit.
1
2
1
2
CLEAN Driver's cab
The frequency of cleaning is given as an example.
IMPORTANT
Do not use a high pressure cleaner or water jet.
Take precautions with electrical and electronic components.
- Clean the inside of the overhead guard or the cab using a small brush, vacuum cleaner and a cloth.
NOTE: As a cap option, protect the cab ventilation filter located under the floor mat.
3 - 13
1
2
647690 (29/01/2019)
M
C . . D K ST3A S1 / MSI . . D K ST3A S5
www.duma-rent.com

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitou MC 25-2 D K ST3A S1 and is the answer not in the manual?

Manitou MC 25-2 D K ST3A S1 Specifications

General IconGeneral
BrandManitou
ModelMC 25-2 D K ST3A S1
CategoryForklifts
LanguageEnglish

Related product manuals