DESKTOP PRINTER SERVICE MANUAL
46
REPLACING THE RIBBON CABLE
QService Notes (p.4).
Replacing the ribbon cable is a lengthy, delicate procedure. When removing the ribbon cable from your printer, it
is important to prevent any other wires from being damaged. This process requires small movements and can
ribbon cable.
Take a moment to read over this section in its entirety before beginning the procedure.
Note: Take care not to discard any hardware you remove during this procedure, as you will need it
during the reinstallation.
Tools
● 2mm hex key
● Phillips #1 screwdriver
● Painter’s tape (or similar tape that will not leave residue on the printer)
● Tape measure
RIBBON CABLE REMOVAL
1. Unloading Plastic and Unloading
Fiber, if applicable, in the User Guide.
2.
3.
4.
5. Disconnect the feed tube from the plastic extruder. Remove it from the printer and set it aside.
6. Tape the lid and visor of the printer closed to prevent them from accidentally opening.
7.
necessary.
8. Turn the printer upside down so that the bottom plate is facing up.
9.
10. Remove the bottom plate and set it aside.
To Next Page
Loading...
