Iris 11
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
IRIS
REPLACE IRIS
1 Separate the framing/iris module and place
the wheel with the shutter blades up.
Remove the bottom and right shutter
blades and partially remove the top blade to
access the 3 iris screws.
2 Remove 3 screws from iris.
3 Turn the wheel over and remove 4 screws
from iris drive plate. Lift out the iris.
4 Insert the new iris with the drive lever at 1
o’clock as shown. Turn the module over,
align the holes, and fasten the iris with the 3
screws.
To Next Page
Loading...
