Gobo animation wheel 14
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
7 Insert the outside guide rail into the sliding
assembly. Snap the outside rail into place.
8 Replace the guide rail retaining brackets.
9 Work the rotation belt over the rotation
motor and tensioner.
10 Replace the gobo animation wheel.
REPLACE POSITION
MOTOR
1 Separate the gobo module from the
framing/iris module to access the inside
motor screw. Unplug and remove motor.
2 Move motor gear to new motor. Install new
motor with plug socket towards the belt
tensioner.
3 Align the motor gear with the belt pulleys
and tighten the set screw.
ADJUSTMENT
The wheel position is electrically indexed: no mechanical adjustment is required.
REPLACE ROTATION BELT
1 Remove the gobo animation wheel.
2 Release tension from the belt and work it
off. This is easier if you separate the
framing/iris module, but it is not necessary
to do so.
To Next Page
Loading...
