Martin MAC 2000 Performance - Replace Shutter Blade

Framing shutters 9
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
REPLACE SHUTTER BLADE
1 Remove the rectangular guide from each
sliding nylon assembly. Place the sliding
assembly on the shutter arm.
2 Position the shutter blade over the sliding
assemblies.
3 Press the rectangular guides into the slots and
onto the brass sleeves.
4 Place the brass discs over the rectangular
slides with the countersink up.
5 Align everything and insert the screws.
Tighten securely.
6 Flip the wheel over and hook the spring onto
the shutter blade pin.