Framing shutters 7
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
FRAMING SHUTTERS
REPLACE MOTOR
The Pozidrive motor screws are locked
with threadlock and can be difficult to
remove without stripping the head.Use
a PZ 0 screwdriver in excellent condi-
tion. Heating the screws well with a
soldering iron softens the threadlock
and makes removal easier.
1 Separate the framing/iris module.
2 Remove the brass discs and lift off the shutter blade. There is a small spring on the
back.
3 Remove the motor screws from the shutter side of the plate. Remove the motor.
4 Remove shutter arm from shaft.
5 Install the new motor and loosely place the shutter arm on the shaft, between the
stops.
1
2
3
4
5
6
1. shutter blade
2. brass discs
3. nylon slide assemblies
4. outside stop
5. shutter arm
6. inside stop
To Next Page
Loading...
